Like all its counter Parts, this network wiring tester comprises two elements, a transmitter unit, powered and fitted at the network start point, and a receiver unit, passive, which can be moved around from socket to socket. Each of these units carries eight LEDS, identically labelled 1 to 8. By operating a push-button in manual mode, or using a clock in automatic, the eight LEDs light up in sequence on the transmitter unit and obviously they should do the same on the receiver unit. In this way, just by watching the LED lighting cycle on the receiver unit, you can immediately spot any crossed wires, as well as any open circuits (the relevant LED never lights up) or shorts (two or more LEDs light at the same time).
Circuit diagram :
Network Wiring Tester Circuit Diagram
The transmitter unit circuit is simple' The Schmitt-input NAND gate lCl.A is wired as a multi-vibrator, whose speed can be adjusted using Pl, while lCl.B is wired as a simple debounce circuit for button 52, used in manual mode. Switch 51 lets you apply the output of one or the other of these to the input of lC3' a decade counter lC, which here we force to count up to eight by connecting its Q8 output back to its reset input. Its out Puts are not capable of driving LEDs, especially over wiring that be 'dangerous' for them (a short, for example), so a ULN2803 is used to drive the outputs. This integrated network of eight Darlington transistors, each capable of switching up to 500 mA, drives the eight LED5 fitted to the transmitter unit (D12-D19) and feeds its signals to the socket comprising contacts 01-08, to which the wiring to be tested must be connected. At the other end of the cable' via the socket comprising contacts l1-18, is the receiver unit which contains just eight LEDs (D20-D27) and their current limiting resistors.
For the latter to work, there obviously needs to be a common connection between transmitter and receiver. In the case of screened network wiring, the screen can be used for this purpose. Another solution consists of using the earth wire of the electrical installation to fulfilthe same function. But if neither of these solutions is feasible, then you'll have to resign your self to running a flying lead for this purpose. The transmitter unit power supply is obtained from a 'plugtop' adapter supplying around 9V at around 10 mA or so. The supply to lCl and lC3 is regulated at 5 V, even though it's not strictly necessary. For occasional short use, a 9 V battery could be used.
lf the project is intended solely for testing network wiring, 01-08 and l1-18 will be in the form of RJ45 sockets and COM will be connected to their screening contact. Take care to stick to the same numbering for the LEDs on the transmitter and receiver units, and if the project is going to be used in automatic mode, that the LEDs are in the correct order.
Author : Christian Tavernier - Copyright : Elektor
Post a Comment